Cost Estimator

JavaScript must be enabled to use this application.
Click here to find out how to enable javascript.

Custom Fields
Name	Value
#1
#2
#3
#4
#5

Disclaimer: The above cost analysis uses data based on industry averages and typical manufacturing practices, and should therefore be viewed only as a guide. Actual costs may vary based on the specific manufacturer, equipment, geographical location, and prevailing market conditions.

Manufacturer:
Designer:
Contact:
Website:
Category:
Industry:
Keywords (comma seperated):


Feature:
Tool:	3/4" Flat end mill (Carbide)
Slot size LxWxD (in):	x x
Depth of cut (in):
Over-run (in):
Surface roughness (μin):
Number of features:
Average spacing (in):


Feature:
Tool:	3/4" Flat end mill (Carbide)
Pocket diameter (in):
Pocket depth (in):
Cutterpath type:
Depth of cut (in):
Step-over (in):
Surface roughness (μin):
Number of features:
Average spacing (in):


Tool:	17/32" Drill bit (Carbide)
Hole type:
Hole depth (in):

Number of holes:
Average spacing (in):


Tool:	13/16" Counterbore (Carbide)
Initial hole diameter (in):
Counterbore depth (in):
Number of holes:
Average spacing (in):

Cost Estimator

About CustomPartNet

Process Overviews

Cost Estimators

Widgets


Tool:	1/2" Drill bit (Carbide)
Hole type:
Hole depth (in):

Number of holes:
Average spacing (in):


Tool:	1/2" - 13 Tap (HSS)
Thread type:
Thread depth (in):
Number of holes:
Average spacing (in):


Tool:	7/16" Drill bit (Carbide)
Hole type:
Hole depth (in):

Number of holes:
Average spacing (in):


Tool:	1/2" Reamer (Carbide)
Initial hole diameter (in):
Ream depth (in):
Finish type:
Number of holes:
Average spacing (in):

Setup
Machine setup time (hours):
Programming or layout time (hours):
Fixture type:
Fixture cost:
Fixture setup time (hrs):
Machine
Workpiece clearance (in):
Rapid travel rate (IPM):
Maximum feed rate (IPM):
Minimum spindle speed (RPM):
Maximum spindle speed (RPM):
Maximum power (HP):
Pallet changer?:	Yes No
Pallet change time (sec):
Tool change
Manual tool change time (sec):
Automatic tool changer?:	Yes No
Automatic tool change time (sec):
Average tool change distance (in):
Labor
Setup effeciency (%):
Setup rate ($/hr):
Minimum setup cost ($):
Labor effeciency (%):
Labor rate ($/hr):
Minimum labor cost ($):
Burden rate ($/hr):
Minimum burden cost ($):

Material:	$1,088 ($10.876 per part)
Production:	$1,997 ($19.974 per part)
Tooling:	$0 ($0.000 per part)
Total:	$3,085 ($30.850 per part)

1. Milling	$3,085 ($30.850 per part)
Material cost	$1,088 ($10.876 per part)
Production cost	$1,997 ($19.974 per part)
Tooling cost	$0 ($0.000 per part)
Total cost	$3,085

Name:
Description:	Part XXXX-040-P010 for the slide assembly